You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
The machine position reported in the object model is out of date immediately after executing M400 following a G1 move.
To reproduce, after homing, run this macro:
The position reported by the echo command is les than 20.000. This is probably because the machine position it not updated if it's been updated within the last 200ms.
This also affects the reported position immediately after a homing or probing move.
The machine position reported in the object model is out of date immediately after executing M400 following a G1 move.
To reproduce, after homing, run this macro:
The position reported by the echo command is les than 20.000. This is probably because the machine position it not updated if it's been updated within the last 200ms.
This also affects the reported position immediately after a homing or probing move.
Original report: https://forum.duet3d.com/topic/33834/minor-problem-with-access-to-object-model-after-g1-commands
The text was updated successfully, but these errors were encountered: