Epson LX-350 / LQ-350 (or other USB Dot-Matrix printers)

[pi43r]

Hi,

I was wondering if anyone tried the LX-350 or LQ-350 USB dot matrix printer on linux already?
I could not find any drivers on openprinting except for the LX-300+. There are also no drivers on the official page.

I have to buy it for a customer and will set it up remotely, so I need to make sure that it works.
It will mainly print pdfs on endless paper.

[zdohnal]

Hi @pi43r ,

I haven't used a dot matrix printer on Linux yet, but if I check models which are provided by CUPS, I see a model for Epson 9-Pin Series printers in Epson manufacturer group in CUPS Web UI - maybe it will work for you, since the model LX-350 is 9-Pin. And Epson 24-Pin Series is there as well, for LQ-350.

[pi43r]

Hi zdohnai,

Thank you for your reply!
I was able to find a used LX-350 in my area and as you mentioned the 9-Pin Series drivers work on that one. So I ordered the LQ-350 and with this one I didn't even have to install it manually. It was found automatically and added to the printer list.

[jsmeix]

Only FYI as addendum my general thoughts about
using dot matrix printers:

I think printing on a dot matrix printer by using
an usual CUPS printer driver does not make much sense
because "using a printer driver" means to use the usual
printing filtering system plus printer driver software
to produce the final printer-specific printing data.

But the usual printing filtering system processing
is based on PostScript and PDF data and usual printer
driver software produces printer-specific PostScript or PDF
or printer-specific raster data (e.g. PCL or ESC/P raster data).

Usually the raster graphics mode on a dot matrix printer
is far too slow with insufficient "dotted" printout quality
to be useful in practice for printing nowadays documents
like web pages or office documents or photos
(in high resolution color).

I think nowadays dot matrix printers are only used to
print plain text characters which are sent directly
(i.e. without any filtering or driver in between)
to the printer device.

E.g. one has files that contain plain text characters
in the right encoding for a specific dot matrix printer
e.g. plain ASCII or another 8-bit single-byte encoding
like ISO-8859-1 or the IBM PC character encoding
but usually no multibyte encoding like UTF-8.

When one has files that contain characters in the right
encoding for a dot matrix printer or when one has an
application that outputs characters in the right encoding
for a dot matrix printer, then one can and should
send that "as is" to the dot matrix printer device
to get printouts with sufficient speed and quality
via the dot matrix printer's built-in character set.