-
Just configured a KNX switch, which triggers my KNX valve actuator for opening a floor heating valve. However, when I configure the smart thermostat to try and increase temperature, my HA log gets filled with the error that the entity is not available. The switch works fine via HA UI. What am I doing wrong? Here is the configuration
The KNX device is a ABB VAA/S 6.230.2.1, https://new.abb.com/products/2CDG110116R0011/vaa-s-6-230-2-1 |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 1 reply
-
Hello, when using a switch or any "binary" entity (on/off, 0/1), you must specify a non null pwm value. |
Beta Was this translation helpful? Give feedback.
Hello, when using a switch or any "binary" entity (on/off, 0/1), you must specify a non null pwm value.
If pwm is 0, you must use an entity with "analog" (0<=>100 or other) state like a valve or an input number.