forked from parallaxinc/Scribbler-3_Library
-
Notifications
You must be signed in to change notification settings - Fork 0
/
Simple_Serial.spin
140 lines (107 loc) · 16.9 KB
/
Simple_Serial.spin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
''*******************************************************************
''* Simple Asynchronous Serial Driver v1.3 *
''* Authors: Chip Gracey, Phil Pilgrim, Jon Williams, Jeff Martin *
''* Copyright (c) 2006 Parallax, Inc. *
''* See end of file for terms of use. *
''*******************************************************************
''
'' Performs asynchronous serial input/output at low baud rates (~19.2K or lower) using high-level code
'' in a blocking fashion (ie: single-cog (serial-process) rather than multi-cog (parallel-process)).
''
'' To perform asynchronous serial communication as a parallel process, use the FullDuplexSerial object instead.
''
''
'' v1.3 - May 7, 2009 - Updated by Jeff Martin to fix rx method bug, noted by Mike Green and others, where uninitialized
'' variable would mangle received byte.
'' v1.2 - March 26, 2008 - Updated by Jeff Martin to conform to Propeller object initialization standards and compress by 11 longs.
'' v1.1 - April 29, 2006 - Updated by Jon Williams for consistency.
''
''
'' The init method MUST be called before the first use of this object.
'' Optionally call finalize after final use to release transmit pin.
''
'' Tested to 19.2 kbaud with clkfreq of 80 MHz (5 MHz crystal, 16x PLL)
VAR
long sin, sout, inverted, bitTime, rxOkay, txOkay
PUB init(rxPin, txPin, baud): Okay
{{Call this method before first use of object to initialize pins and baud rate.
• For true mode (start bit = 0), use positive baud value. Ex: serial.init(0, 1, 9600)
For inverted mode (start bit = 1), use negative baud value. Ex: serial.init(0, 1, -9600)
• Specify -1 for "unused" rxPin or txPin if only one-way communication desired.
• Specify same value for rxPin and txPin for bi-directional communication on that pin and connect a pull-up/pull-down resistor
to that pin (depending on true/inverted mode) since pin will set it to hi-z (input) at the end of transmission to avoid
electrical conflicts. See "Same-Pin (Bi-Directional)" examples, below.
EXAMPLES:
Standard Two-Pin Bi-Directional True/Inverted Modes Standard One-Pin Uni-Directional True/Inverted Mode
Ex: serial.init(0, 1, ±9600) Ex: serial.init(0, -1, ±9600) -or- serial.init(-1, 0, ±9600)
┌────────────┐ ┌──────────┐ ┌────────────┐ ┌──────────┐
│Propeller P0├─────────────┤I/O Device│ │Propeller P0├───────────────┤I/O Device│
│ P1├─────────────┤ │ └────────────┘ └──────────┘
└────────────┘ └──────────┘
Same-Pin (Bi-Directional) True Mode Same-Pin (Bi-Directional) Inverted Mode
Ex: serial.init(0, 0, 9600) Ex: serial.init(0, 0, -9600)
┌────────────┐ ┌──────────┐
│ │Propeller P0├─────┳─────┤I/O Device│
4.7 kΩ └────────────┘ │ └──────────┘
┌────────────┐ │ ┌──────────┐ 4.7 kΩ
│Propeller P0├─────┻─────┤I/O Device│ │
└────────────┘ └──────────┘
}}
finalize ' clean-up if restart
rxOkay := rxPin > -1 ' receiving?
txOkay := txPin > -1 ' transmitting?
sin := rxPin & $1F ' set rx pin
sout := txPin & $1F ' set tx pin
inverted := baud < 0 ' set inverted flag
bitTime := clkfreq / ||baud ' calculate serial bit time
return rxOkay | TxOkay
PUB finalize
{{Call this method after final use of object to release transmit pin.}}
if txOkay ' if tx enabled
dira[sout]~ ' float tx pin
rxOkay := txOkay := false
PUB rx: rxByte | t
{{ Receive a byte; blocks caller until byte received. }}
if rxOkay
dira[sin]~ ' make rx pin an input
waitpeq(inverted & |< sin, |< sin, 0) ' wait for start bit
t := cnt + bitTime >> 1 ' sync + 1/2 bit
repeat 8
waitcnt(t += bitTime) ' wait for middle of bit
rxByte := ina[sin] << 7 | rxByte >> 1 ' sample bit
waitcnt(t + bitTime) ' allow for stop bit
rxByte := (rxByte ^ inverted) & $FF ' adjust for mode and strip off high bits
PUB tx(txByte) | t
{{ Transmit a byte; blocks caller until byte transmitted. }}
if txOkay
outa[sout] := !inverted ' set idle state
dira[sout]~~ ' make tx pin an output
txByte := ((txByte | $100) << 2) ^ inverted ' add stop bit, set mode
t := cnt ' sync
repeat 10 ' start + eight data bits + stop
waitcnt(t += bitTime) ' wait bit time
outa[sout] := (txByte >>= 1) & 1 ' output bit (true mode)
if sout == sin
dira[sout]~ ' release to pull-up/pull-down
PUB str(strAddr)
{{ Transmit z-string at strAddr; blocks caller until string transmitted. }}
if txOkay
repeat strsize(strAddr) ' for each character in string
tx(byte[strAddr++]) ' write the character
{{
┌──────────────────────────────────────────────────────────────────────────────────────────────────────────────────────────────┐
│ TERMS OF USE: MIT License │
├──────────────────────────────────────────────────────────────────────────────────────────────────────────────────────────────┤
│Permission is hereby granted, free of charge, to any person obtaining a copy of this software and associated documentation │
│files (the "Software"), to deal in the Software without restriction, including without limitation the rights to use, copy, │
│modify, merge, publish, distribute, sublicense, and/or sell copies of the Software, and to permit persons to whom the Software│
│is furnished to do so, subject to the following conditions: │
│ │
│The above copyright notice and this permission notice shall be included in all copies or substantial portions of the Software.│
│ │
│THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, EXPRESS OR IMPLIED, INCLUDING BUT NOT LIMITED TO THE │
│WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT. IN NO EVENT SHALL THE AUTHORS OR │
│COPYRIGHT HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER LIABILITY, WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, │
│ARISING FROM, OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR OTHER DEALINGS IN THE SOFTWARE. │
└──────────────────────────────────────────────────────────────────────────────────────────────────────────────────────────────┘
}}