-
Notifications
You must be signed in to change notification settings - Fork 0
/
config.txt
92 lines (64 loc) · 1.99 KB
/
config.txt
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
# Raspberry Pi configuration file
# For more options and information see
# http://www.raspberrypi.org/documentation/configuration/config-txt.md
###
# Config Options
###
### Sets the memory split between the CPU and GPU
gpu_mem=32
### Disable rainbow splash at boot
disable_splash=1
### Raspberry camera module (requires gpu_mem >= 128 MB)
#start_x=1
#disable_camera_led=1
### UART console when booting RPi3
#enable_uart=1
### Display Options
# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1
# Use HDMI mode even if no HDMI monitor is detected
#hdmi_force_hotplug=1
# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
#disable_overscan=1
# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=16
#overscan_right=16
#overscan_top=16
#overscan_bottom=16
# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720
# uncomment to force a specific HDMI mode (this will force VGA)
#hdmi_group=1
#hdmi_mode=1
# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
#hdmi_drive=2
# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
#config_hdmi_boost=4
# uncomment for composite PAL
#sdtv_mode=2
###
# Device Tree overlays and parameters
###
### Uncomment some or all of these to enable the optional hardware interfaces
# Completely disable device tree overlays
#device_tree=
### Base dtb paramters.
### Refer to /boot/overlay/README for detailed parameter descriptions
dtparam=audio=on
#dtparam=i2c=on
#dtparam=i2s=on
#dtparam=spi=on
#dtparam=watchdog=on
### Configs specifically for RPi4
[pi4]
# Enable DRM VC4 V3D driver on top of dispmanx display stack
dtoverlay=vc4-fkms-v3d
max_framebuffers=2
### Configs for all other RPi revisions
[all]