forked from nick-parker/Bread
-
Notifications
You must be signed in to change notification settings - Fork 0
/
config.txt
29 lines (29 loc) · 1.35 KB
/
config.txt
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
//Configure accordingly for your machine.
layerHeight 0.3 mm
filD 1.75 mm //filament diameter, set your own.
nozzleD 0.4 mm //nozzle diameter, set your own.
extrusionWidth .55 mm //Set to about 11/8 nozzleD. Subject to change.
printTemp 200 C //Set for your plastic.
xySpeed 20 mm/s //Max speed on XY, i just set this low for the first prints.
zSpeed 7 mm/s //Maximum speed on your z axis. Set this low at first, they're easy to stall...
numShells 3 //Number of outer shells
infillWidth 4.5 mm //Distance between lines of infill on non-solid layers.
lift 0 mm //Z lift for travels, should be half the layer height or slightly less.
retraction 1.2 mm //retraction
retractSpeed 70 mm/s
retractThreshold 10 mm //Minimum XY travel distance to trigger retraction.
topLayers 5 //Solid layers on the top.
botLayers 5 //Solid layers on the bottom.
AllSolid true //Print all layers as solid.
brimCount 11
TipRadius 0.2 //Used for nozzle compensation, set to 0 to disable.
FirmwareRetract false
OuterFirst false //Print shells outside first or inside first. In general, try to print lower ones first.
EnableSupport false
FiveAxis false
XMax 200 mm //Dimmensions of your print bed.
YMax 200 mm
ZMax 200 mm
XMin 0 mm
YMin 0 mm
ZMin 0 mm