Wallbox Pulsar Plus momentary power or current readings? #449
Replies: 2 comments 3 replies
-
Have a look at the bottom of this page and you will see the useful Metrics (sensors) which work for me with V5.5.10... |
Beta Was this translation helpful? Give feedback.
-
Works for me as well. The reason I change from the "official" Wallbox integration using the myWallbox cloud service was that the momentary power readings wasn't working correct. It only showed the power in the beginning of each session and then it went down to 0. I saw the same behavior in the Wallbox portal. I now have both of them running, and I see that it still behaves the same in the "official" integration, but this integration (OCPP) works perfect! |
Beta Was this translation helpful? Give feedback.
-
Hi all,
due to network connectivity reasons, I am currently stuck with SW version
5.3.20
on the Pulsar Plus. I never got5.5.10
running to date.With
5.3.20
, the only metering sensor values I get areenergy
sensors:Any
current
orpower
sensors are either 0 or Unknown. So I wonder if this is expected, or if5.5.10
, which I couldn't get to work yet, would offer some more?Thanks a lot!
Beta Was this translation helpful? Give feedback.
All reactions