start/stop server by batch commands

[kawasaki500]

Hi. Very good job!
I am trying the server on a W10 22H2 pc and it is working very well!

Normally, I don't leave my servers open all the time, but I start and stop them using batch commands sent from remote internet by SSH (i.e. service vpnserver1 start)
I don't see a procedure in WS4W to make this, but:

• to stop wireguard I can in the order by WgServerforWindows.exe (GUI interface):

1. disable NAT routing
2. uninstall tunnel service

• to start (reenable) I can:

1. install tunnel service
2. enable NAT routing

So, should it be easy to have some corresponding commands in the CLI interface...

Moreover, why the server interface is named wg_server instead of wg0, as usual?

Thank you, hope in your help. All the best