-
Notifications
You must be signed in to change notification settings - Fork 132
New issue
Have a question about this project? Sign up for a free GitHub account to open an issue and contact its maintainers and the community.
By clicking “Sign up for GitHub”, you agree to our terms of service and privacy statement. We’ll occasionally send you account related emails.
Already on GitHub? Sign in to your account
Shelly Plus 1 Doorbell 12 V AC - only "long" press is detected #1444
Comments
Hi, maybe can you post some logs? There is a detection for long and short presses, which might somehow lead to that. |
I opened the log and pressed a few times (I think at least 6 times). Only got 3 notifications from homekit:
|
Your short presses are interpreted as double taps and thus trigger only one ring... ? |
I dont really know how to read the logs. But I left it untouched for 30 minutes before, made one ring and it was not recognized. That's why I started investigating. Just from my feeling the switch has to be pressed harder than with stock shelly firmware. But that does not really makes sense I guess |
No it does not really make sense. Or maybe only after we look deeper. There is a detection mechanism for short, long and double press, which is actually not needed for a bell. Maybe this stands in the way. Can you really isolate the event in time when you test and try to annotate in your log what you really did? |
I will try to make some better tests when I find time (might take a while) |
I can confirm that, I have a similar behavior with an UNI. |
Hello,
I used a Shelly Plus 1 as Doorbell for a few weeks. My old doorbell uses 12 Volt AC so I have running via 12 V transformer rectifier. The physical switch still as 12 V AC which is connected to SW. This works without problems in the stock shelly firmware. But only without eco mode.
I used it via Home Assistant to get notifications.
Now I noticed it's possible to add my setup to Homekit without the need for home assistant. So I installed the Homekit firmware and set it up. Everything looks great but then I noticed I started missing rings. So I began to test and noticed I have to press the switch longer than with the shelly stock firmware to trigger it. So when you just press it for a very short time it does not work. I just reverted to shelly firmware and the problem is gone.
Is this a bug? I'd prefer to use the homekit firmware but I guess I will miss most rings.
The text was updated successfully, but these errors were encountered: