+2PM: Window open close time manually

[RickShen007]

Because of my cover is triggered the open close action by wet contact( high voltage), not consum any power at all, so calibration will not work. set the open close time period manually is the only solution. Thanks

[markirb]

Are you talking about Window Opener?

How you you open your windows without consuming power? :) - Does the Motor have an own controller and is wired to power separately or what?

[RickShen007]

Are you talking about Window Opener?

How you you open your windows without consuming power? :) - Does the Motor have an own controller and is wired to power separately or what?

No，not windowz opener， just roller shade， but its has controller inside，open close wire is is just a contact closure to active open or close. So no power needed on output 1 or 2. So Shelly 2pm can not measure the power output, then calibration failed. Set open and close time manually is the only solution.

[markirb]

So it reacts on a pulse? Why need a timer then? Or do you press as long as it should go down?

[RickShen007]

So it reacts on a pulse? Why need a timer then? Or do you press as long as it should go down?

Yep, need pressed as going down or up. calibration failed, just run 3-5sec then stop, and position function is not work without calibration. Open close in home app not work properly. If I can set open close timer, maybe it can calculate the position by time? In stock firmware, I can set just the max time limit to make it works without calibration. In HomeKit only works calibration I think

[markirb]

so I think you need this?

#449

if you can rebase this onto current master then your alle set...