Jlink setup
#470
Replies: 0 comments
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
{{ message }}
-
Might be an elementary question here, but in the Board Manager instructions for the Segger J-link, Step 6 is "Replace Driver". but...replace it with what?
It appears that after the driver is replaced, then the Arduino IDE can talk to the nrf52x? After flashing the correct SoftDevice, are there any other steps necessary to be able to upload sketches? (presuming the correct board, softdevice, clock, port, and programmer are selected)
Beta Was this translation helpful? Give feedback.
All reactions