You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
User story
As a user in Sample Management, scanning in Heron plates and racks, if a plate or rack does not import successfully, I would like to tell if it has already been imported or whether it failed for a different reason.
Who are the primary contacts for this story
Danni
Acceptance criteria
To be considered successful the solution must allow:
When I 'receive' a plate or rack into Asset Audits, if it is not imported, I would like to be told whether that's because it already exists in Sequencescape or another reason.
Imported? box in results table says 'Yes', 'No' or 'Fail' depending on whether the import was successful, it has been previously imported into SS or it failed to import
Additional context
Came out of UAT of sanger/sequencescape#2772
Current results table looks like this - it just says 'No' under 'Imported?' if the labware was not imported
The text was updated successfully, but these errors were encountered:
User story
As a user in Sample Management, scanning in Heron plates and racks, if a plate or rack does not import successfully, I would like to tell if it has already been imported or whether it failed for a different reason.
Who are the primary contacts for this story
Danni
Acceptance criteria
To be considered successful the solution must allow:
Additional context
Came out of UAT of sanger/sequencescape#2772
Current results table looks like this - it just says 'No' under 'Imported?' if the labware was not imported
The text was updated successfully, but these errors were encountered: