BottomLightPWM_xxx and the LightPWM_xxx for Anycubic Photon Mono X #163
-
|
Anycubuc photon Mono x; |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 7 replies
-
|
If it doesn't show for that format, that means it's not supported by the format itself. If you want to weaken LED power you must dim pixels instead or use less exposure as alternative |
Beta Was this translation helpful? Give feedback.
-
|
Oops maybe I asked my question incorrectly. on photon mono x you can set the power manually. I had hoped that this could also be done via the software ... |
Beta Was this translation helpful? Give feedback.
-
|
AFAIK is not possible via software |
Beta Was this translation helpful? Give feedback.
-
|
why then is there a possibility in prusaslicer profiles to adjust LightPWM_xxx? |
Beta Was this translation helpful? Give feedback.
-
|
Maybe i forgot to remove that unused variables when i was copying printers... |
Beta Was this translation helpful? Give feedback.
-
|
Here you can find a list of supported variables for the format which is also what uvtools shows under edit parameters: https://github.com/sn4k3/UVtools/blob/master/UVtools.Core/FileFormats/PhotonWorkshopFile.cs#L923 Commented lines (//) are to ignore |
Beta Was this translation helpful? Give feedback.
If it doesn't show for that format, that means it's not supported by the format itself.
Even the formats that support that, most don't respect nor use it anyway because LED is only ON or OFF and not controlable on most printers.
If you want to weaken LED power you must dim pixels instead or use less exposure as alternative