Help wanted with KT48ZWSRKT-SJT02L

[zimivanende]

Hello,

• High Speed Motor => makes it go much faster but sometimes the throttle doesn't work untill you turn the weel slightly. Why is this happening? Should I keep this disabled?

• Enable rotor angle correction => you suggest to disable it on my type of controller =>

• • disabled: uses less current in the end (doesn't keep trying to go faster) and has a lower top speed
• • enabled: keeps using high current and goes 5-10 kph faster
    What do you recommend?

• Disable Interpolation => you recommend to enable it on my type of controller => it makes so much more noise and drives rough and slower. So should i keep it enabled even though it is much worse?

• Motor specific angle uses the least amount of power at 0 but doesn't go the full motor speed (135 watts). At about 26 it uses 400 watts and goes full speed. What should I do? Also as a side note from 0 to 26 is gradualy increases in power use and keeps it's top speed untill 35 the it is using even more power and starts to go slower again.

Could you give me your opinion on this?

Also i try to enable the cheat code (which enables the offroad mode) i ste morse 1 and 2 and 3 to 50 and enabled off-road mode. Set speed limit and without pas to 25 and offroad to 70 but the morse code doesn't seem to enable the offroad mode? What am I doing wrong here.

Kind regards

[zimivanende]

Also when does the rotor angle correction happen?

Because now I set the motor specific angle to 0 which is the most efficient and advanced the rotor angle correction with 33 and I now reach the same speeds as the inefficient motor specific angle at 33

[zimivanende]

Bump