"send Config" won't work (Ubuntu 20)

[adizag]

Unable to send config after flashing. nor get an IP address (shows xx.xx.xx.xx).
getting a message from Tasmotizer but nothing happens.

[jziolkowski]

The problem with send config and IP read is that there is not 100% reliable way of checking device state after flashing.
Which device are you using? What settings?

[OfferLa]

For me, Sonoff Basic, Windows 10, Tasmotizer is flashing ok, can send SSID by 'send config', but never succeeded to get ip by tasmotizer query button. From: Jacek Ziółkowski [mailto:[email protected]] Sent: Sunday, January 10, 2021 10:46 PM To: tasmota/tasmotizer Cc: Subscribed Subject: Re: [tasmota/tasmotizer] "send Config" won't work (Ubuntu 20) (#73) The problem with send config and IP read is that there is not 100% reliable way of checking device state after flashing. Which device are you using? What settings? — You are receiving this because you are subscribed to this thread. Reply to this email directly, view it on GitHub <#73 (comment)> , or unsubscribe <https://github.com/notifications/unsubscribe-auth/ACUTS2FQN5NLCAF3P6HHAWDSZIGW3ANCNFSM4V33IRHA> . <https://github.com/notifications/beacon/ACUTS2DIN4B4T2MTVQYBYRDSZIGW3A5CNFSM4V33IRHKYY3PNVWWK3TUL52HS4DFVREXG43VMVBW63LNMVXHJKTDN5WW2ZLOORPWSZGOFUTSSZI.gif>

[jziolkowski]

Do you restart and/or power cycle the device after flashing?

[adizag]

@jziolkowski
I'm on Ubuntu 20, installed both with method 2 and 3 in the readme.
flashing sonoff T1, tried power cycle several times, Tried setting SSID MQTT settings.

I had some problems with pre-required python packages at the beginning (showed as an error in terminal) but I can't see any similar message now.

[pafribouf]

Workaround: use esptool

[sausin]

Having the same issue as @adizag. On v1.2.1

Send config was done after power cycling and removing connection to GND. However, in all trials so far it didn't work either with ESP8266-01 or ESP8266 12-E NodeMCU