Retraction and Temp Test (models not centered)

[AvengingNorse]

I tried making a retraction and temp test today but no matter what parameters I apply, the models will not center on the bed.
Everything is crammed into the back corner.

I tried printing it and it would just run over what it already printed, resulting in the extruder assembly being lifted and drug over the printed part. IDK what hell it was doing, maybe stacking the towers.

Anyone have any tips?
This isn't the first time I've used this site to make tests, but it is the first time that I've had any issues, so I'm a bit perplexed.