Config.Json missing causing a loop? #866
-
Hello! I'm using ring-mqtt via docker compose; noticed when doing some recent poking that it is looping a restarting status. Checked the logs via portainer and I'm getting this
I used docker compose to do this. The portion of my compose yaml for ring-mqtt is below (exact copy paste from the setup page):
When looking at the folder in terminal, there is nothing in the /opt/ring-mqtt folder at all. I completely removed the container and did a fresh docker compose up -d and issue is same. I also cannot find anything about setup of the config.json in the help articles so a little lost on what's going on here, hoepfully someone can help! :) |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 1 reply
-
Documentation for docker installation covers the steps required to perform authentication and create the initial configuration file, so I'm not really sure why you are unable to find anything about it, it is part of the required authentication step. If you started fresh, then just follow those steps as documented. |
Beta Was this translation helpful? Give feedback.
Documentation for docker installation covers the steps required to perform authentication and create the initial configuration file, so I'm not really sure why you are unable to find anything about it, it is part of the required authentication step. If you started fresh, then just follow those steps as documented.