Is a z80 ASM NMRA-DCC throttle implementation for the TI-84 Plus C Silver Edition.
- Custom DCC throttle interface.
- FL-F26 Function support with momentary/locking functions
- 14/28/128 step speed modes
- 2 Digit and 4 Digit addressing
- Analog/DC throttle mode - To be implmented.
- Verify 14/128 step speed modes
- Verify Long addresses work
- Finish Reccomended schematic
- Python 2.* and the python launcher. (comes with py3...)
- Pillow
- Motor driver - A motor driver/H-bridge and circuit used to generate the on rail signals for the train.
- Power supply for the motor driver. Voltage is based off of the scale train you plan on controlling. See the NMRA Standards linked at the bottom of this readme
- LMD18200 using this circuit MiniDCC
- run _buildclean.bat
- Transfer application to calculator using TI-Connect or TILP
- NumberPad: Set Addresss
- F1-F3: set Speed steps mode
- F4: Set DC Controll mode
- F5: Save Changes
- Left/Right: Set Forward or Reverse movement
- Up/Down: Adjust throttle
- Number Pad: Control functions
- F1-F3: Switch between function banks
- CFG: Open configuration view
- Lock: Allows changing of function type
- Math: Quit
- Enter: E-Stop
- SIN: Change read out colors
- Forum Topic: http://cemete.ch/p261712
- NMRA Documentation: https://www.nmra.org/index-nmra-standards-and-recommended-practices