Voron2.4-Config

My backup Voron 2.4 config that contains instructions- 250x250x250

🎯Wiring

B stepper motor → Driver0
A stepper motor → Driver1
Z0 (front left) stepper motor → Driver2-2 (leaving an empty connector between B/A and Z0)
Z1 (rear left) stepper motor → Driver3
Z2 (rear right) stepper motor → Driver4
Z3 (front right) stepper motor → Driver5
Extruder stepper motor → Driver7 (leaving an empty connector between Z3 and extruder)
Filament Runout Sensor → X-
X endstop switch → X+
Y endstop switch → Y+
Z endstop switch → Z-
Inductive probe (with BAT85) → Z+
Bed thermistor → TB
Hotend thermistor → TH0
Chamber thermistor → TH1
Frame thermistor → TH2
Hotend fan → FAN0 (See markings on back of board)
Print cooling fan → FAN1 (See markings on back of board)
Exhaust fan → FAN2 (See markings on back of board)
MKS Mini 13864 v3 → EXP1 and EXP2
SSR input → H-BED (See markings on back of board)
Hotend heater → HE0
Controller fan → HE1
Single-colour 24V LED strip → HE2 :coffin:

✅ Required jumper settings

Endstop - PWR → VIN
SPI/UART → UART configuration (see back of board)
Driver DIAG → No jumpers installed
Drive IC - PWR → 5V USB-PWR → OFF

Other jumper settings

Each fan connector has a corresponding FAN-PWR jumper, which allows each individual fan to be ran with 5V, 12V, or 24V.

Klipper config

[*] Enable extra low-level configuration options
    Micro-controller Architecture (STMicroelectronics STM32)  --->
    Processor model (STM32F407)  --->
    Bootloader offset (48KiB bootloader (MKS Robin Nano V3))  --->
    Clock Reference (8 MHz crystal)  --->
    Communication interface (USB (on PA11/PA12))  --->
    USB ids  --->
()  GPIO pins to set at micro-controller startup

👨🏻‍💻 Other links

Voron-Design
Super-Slicer
MKS Monster8 Voron config by makerbase