An Arduino library to control Milight / LimitlessLED LED strip controllers via an ethernet shield and their wifi bridge
void Milight::begin(EthernetUDP *udp, IPAddress* addr, uint16_t port)The begin() function sets up the Milight control object, connects it with an active Ethernet Shield control library, and tells it where to find the Milight Wifi gateway. When the EthernetUDP object is passed in, it should already be initialized and active.
addr is the address of the target Milight Wifi gateway, and port is the UDP port on which to connect.
void Milight::on(uint8_t channel, uint8_t color, uint8_t intensity)The on() method sets a given channel to a certain color and intensity.
channel is a number, 0-4. 0 means 'all channels', whereas 1-4 correspond to channels 1-4 on the controller
color is a number 0x00-0xFF. The colors are as defined by Milight / LimitlessLED, except for 0x00, which is overloaded to be "white"
intensity is a percentage, 0-100. 0 is the same as executing the off() method, and will shut off the LEDs on a given channel. 100 is full on.
void Milight::off(uint8_t channel)The off() method shuts off a given channel.
channel is a number, 0-4. 0 means 'all channels', whereas 1-4 correspond to channels 1-4 on the controller
void Milight::workQueue()The workQueue() function should be called each time around the loop. It checks if there are commands queued up to be sent (they can only be sent to the gateway so quickly) and if enough time has passed, it will transmit one. Otherwise it returns immediately. Your main loop() function should not stall, otherwise packets will not get transmitted in a timely fashion.