Hardware files to build the Development Board 2.3.1

Same as 2.3 but then with the typo's fixed

Hardware files to build the Development Board 2.3

A more minimal configuration where you can also break off the sensor side and use a QWIIC connect to use it. 😎

Hardware files to build the Development Board 2.2

Potential fix for #18
Potential fix for #19
Fix #20
Fix #21

Hardware files to build the Development Board 2.1.1

This release

• Changes two names on the silkscreen (they were swapped) fixes issue #9
• Adds GND pad to the board for easy testing, fixes issue #10
• Adds gerbers as a .zip for easy ordering of the PCB
• Adds the right current limiting resistors to get a better signal (and only need to order one resistor value) fixes issue #14

Hardware files to build the Development Board 2.1

Howdy👋,
We made an updated version of Development Board 2.0, squeezing bugs and converting the whole project to KiCad, making it easy for you to contribute to!
Cheers from the Plastic Scanner Team

Hardware files to build the Development Board 2.0

✌️Hi all,
This is the first release of the Development Board 2. It was based on hardware we designed in 2021.
The Development board 2.0 release is not intended to be replicated, we already found several bugs (#1 , #2, #3, #4, #5, #6, #7 ) in the design. It is purely made as a placeholder and to show what kind of files we will be sharing in the future with the next releases.

Full Changelog: https://github.com/Plastic-Scanner/DB2.x-Hardware/commits/2.0