UltimakerRamps

Marlin firmware for the Ultimaker, upgraded to a RAMPS1.4 board and the J-Head hot-end

Warning: it seems that temperature0 is dead, so i switched out temp0 and temp1. This means that the heater-temperaturesensor needs to be attached to t1

What to do when someone screws over the firmware

Step One

Clone this repo.

Step Two

Open Marlin.ino with Arduino (should be installed on the Stadslab computer already). Connect the Ultimaker to the computer (if not already). Press upload .

Step Three

???

Step Four

Profit. The Ultimaker firmware should be succesfully uploaded to the Arduino Mega.