Joost's custom Slic3r settings for his Prusa i3 mk2s. ( ~/..Slic3r )

rigid.ink ASA 1.75mm

• first layer temperature: 235
• first layer printing bed temperature: 100
• subsequent layers temperature: 230
• subsequent layers printing bed temperature: 90
• printing bed: clean PEI
• printer in enclosure
• fan speed: 10%
• bridge fan speed: 30%

rigid.ink BIOFLEX 1.75mm

• first layer temperature: 240
• first layer printing bed temperature: 55
• subsequent layers temperature: 235
• subsequent layers printing bed temperature: 50
• printing bed: glue stick (to avoid it sticking to the bed permanently)
• print without enclosure
• fan speed: 85%
• bridge fan speed: 100%
• further tuning is needed (retraction, slowing down, ...)

rigid.ink PET 1.75mm

• first layer temperature: 235
• first layer printing bed temperature: 80
• subsequent layers temperature: 230
• subsequent layers printing bed temperature: 80
• printing bed: window cleaner (silicone) (to avoid it sticking to the bed)
• print without enclosure
• fan speed: 30%
• bridge fan speed: 50%
• print off center for small parts to avoid the part cooling fan cooling down the bed to much

rigid.ink PLA 1.75mm

• first layer temperature: 195
• first layer printing bed temperature: 55
• subsequent layers temperature: 180
• subsequent layers printing bed temperature: 45
• printing bed: clean PEI, cleaned with Isopropanol Alcohol
• print without enclosure
• fan speed: 85%
• bridge fan speed: 100%
• even lower bed temperature might still be possible