Add DawPad

[CoffeeCoder1]

• I HAVE RAN DRC ON MY DESIGN WITH ZERO ERRORS (Silkscreen errors are okay)
  • There are a few errors related to the clearances between the LEDs and the switches, but those should be fine because the LEDs are reverse mount (I followed the Hackpad guide on adding them, so the positioning should be correct).
• I HAVE BRANDED ALL MY PARTS (PCB, CASE) WITH MY HACKPAD'S NAME
• I HAVE MADE SURE MY 3D PRINTED PARTS DO NOT REQUIRE SUPPORTS (Text branding overhang is okay)
• I HAVE MADE SURE TO INCLUDE TOLERANCES (0.25mm)
• MY HACKPAD'S PCB IS UNDER 100mm x 100mm, I DO NOT HAVE MORE THAN 16X SWITCHES, 2X ROTARY ENCODERS, 1X OLED, 16X LEDS.
  • I do have more than 2 rotary encoders, but I figure that can be a part of the $20 grant.
• IN MY FOLDER, THERE IS A README.MD FILE THAT CONTAINS THE FOLLOWING INFORMATION:
  • Full render including all the parts
  • A few sentences about the inspiration and challenges
  • BOM
  • Photos of the Schematic, PCB, and case

I still have to finish up some small things, as are listed above (I can do these sometime tonight), but this is at least in a state where it should be able to be reviewed (all the actual functionality is done, it's just some branding stuff and some small case adjustments that need to be made).

This contains the changes from #480 since I needed submodules to work, since I'm using them for some footprint libraries.

[vercel]

The latest updates on your projects. Learn more about Vercel for Git ↗︎

Name	Status	Preview	Comments	Updated (UTC)
hackpad	✅ Ready (Inspect)	Visit Preview	💬 Add feedback	Feb 25, 2025 2:58pm