Firmware files for meshy-tron

The firmware is based off the arduino platform and uses the command line version of the ide known as arduino-cli. Meshy-tron uses an esp32s3 clone board with the following pinout.

Instructions

Step 1. Install arduino-cli

You can find the installation instructions here.

---

Step 2. Clone the repository and checkout to the master branch

---

Step 3. Install the core and dev-tools

cd to the cloned repository and run make dev.

This will take a few minutes to download.

---

Step 4. Time to compile!

run make.

This will produce a set of bin files under a directory called build.

---

Step 5. Upload

connect the meshy-tron though usb and run make upload-all.

Upload is slow and will take several seconds as its through UART. Hopefully switching to USB in the future. It's recommeded that make upload is used after the first make upload-all. This skips uploading the bootloader and the partition info shaving a few seconds.