Coreception 300 With BL touch - marlin 2.0.9.1

Coreception 300 With BL touch - marlin 2.0.9.1

Keep both Z stops plugged in. (EDIT: this firmware has invalidated this. we now use G34 to level axis to .001mm, much more reliable.) unplug the Z stops and remove them if you have a Bl touch.
plug in Bl touch as pictured on this Github page (material runout sensor 2)

DISCLAIMER : I am not responsible for anything. ever.

QuickStart guide for New Firmware with Coreception (or any marlin printer)
Place binfile into SD card
Turn off machine Put in SD card, turn on machine
If you it ask about Eeprom, Intialize.
If it says "top left" Touch top left, bottom left, top right ,bottom right to calibrate screen, it should then say "calibration complete" and freeze for 10 seconds.
CALIBRATION NEEDED - NEW FIRMWARE
GO TO Main-> configuration->Advanced settings-> tempurature - >
PID autotune E1 a(at print temp most often used)+ PIN autotune Bed (at temp most often used) - Run both commands
A GO TO Main-> configuration->Advanced settings->probe offset->Z Probe Wizard - Run that
B Lower Z by 1 mm until Nozzle to bed is close...
C lower z by .025 or smaller while sliding a piece of paper under a clean nozzle UNTIL slight friction can be felt.
Go TO main->configuration -> Store settings
Start a print test calibration cube.
Watch while print starts if first layer isn't perfect, click the XYZ position bar (on Color Touchscreens) to enter babystepping mode which will change your initial Probe Z offset (takes 10 presses to change .01 to .02), proceed to Change Z height to fit your material.(If you do change the settings, repeat step 9)

Coreception With BLTouch

Coreception with BLTouch And both Leveling Zaxis Endstops working beta release 1.

I am not responsible for anything. ever.