Releases
1.4.4
Features:
M851 and Babystepping is combined, so Babystepping can be used to alter the current Z Offset while printing.
Enable M808 gcode for repeat markers (thanks @stklcode )
The correct Marlin Version is now shown instead of just "2.0.x".
Bugfixes:
4MAX Pro now correctly resets after boot.
Fix build error because the TMC26XX Library was removed.
Fix Pause via USB print, which is not automatically resumed now.
Fix missing software endstop on Z_MIN.
Known Issues:
The built-in leveling of the 4MAX Pro does not work yet. Use the 4-point-easy leveling and mesh leveling via the special menu instead.
The Mega Pro BMP Laser feature is not (yet) supported. Use the M3 Spindle/Laser feature instead.
On Chiron, when setting the Z offset manually, the Nozzle does not move to give you "live feedback". The Offset is only applied after X/Y movement.
The Nozzle temperature can only be set over 260°C via gcode and not the Touchscreen. This issue can not be fixed.
The gcode filetransfer via Wifi is pretty slow due to to hardware limitations.
If the print is paused, it can not be resumed via the Display UI. Please print via USB/Octoprint instead!
How to Install:
Follow the Beginner's Guide which is also available in german as "Einsteiger Leitfaden" .
Read the FAQ which can also be found in the Wiki .
If you own a MEGA S or MEGA PRO, set your Bed size in your Slicer to these values .
Use Cura , PrusaSlicer or xLoader to flash the Firmware to your Printer.
Important:
Be sure to select "LOAD FW DEFAULTS" and "SAVE EEPROM" via Special Menu after updating!
You can’t perform that action at this time.