1.5.1
*This version was hotfixed on 2023-06-13.
New Features:
- Update Codebase to Marlin 2.1.2.1 (Thanks @stklcode !)
- Faster file list load/refresh
- Support for SD Card extenders
Bugfixes:
- In some cases, printers with Anycubic 1.0 Displays had issues reading the SD card or crashed at startup
- When scrolling many times though the file list, the Output got scrambled on DGUS Clone Screens
- Sometimes after long prints the elapsed time showed --.--
- When no filament sensor is connected, there was a boot loop on printers with Anycubic 1.0 Displays
Known Issues:
- The built-in leveling of the 4MAX Pro does not work yet. Use the 4-point-easy leveling and mesh leveling via the special menu instead.
- The Mega Pro BMP Laser feature is not (yet) supported. Use the M3 Spindle/Laser feature instead.
- The Nozzle temperature can only be set over 260°C via gcode and not the Touchscreen. This issue can not be fixed.
- The gcode filetransfer via Wifi is pretty slow due to to hardware limitations.
How to Install:
- Follow the Beginner's Guide which is also available in german as "Einsteiger Leitfaden".
- Read the FAQ which can also be found in the Wiki.
- If you own a MEGA S or MEGA PRO, set your Bed size in your Slicer to these values.
- Use Cura, PrusaSlicer or xLoader to flash the Firmware to your Printer.