1.5.2
New Features:
- Add Marlin M73 Support to get a more accurate print time display
- Improve overall stability (Thanks @stklcode !)
Bugfixes:
- Heater error check on boot did not trigger at all
Known Issues:
- The built-in leveling of the 4MAX Pro does not work yet. Use the 4-point-easy leveling and mesh leveling via the special menu instead.
- The Mega Pro BMP Laser feature is not (yet) supported. Use the M3 Spindle/Laser feature instead.
- The Nozzle temperature can only be set over 260°C via gcode and not the Touchscreen. This issue can not be fixed.
- The gcode filetransfer via Wifi is pretty slow due to to hardware limitations.
How to Install:
- Follow the Beginner's Guide which is also available in german as "Einsteiger Leitfaden".
- Read the FAQ which can also be found in the Wiki.
- If you own a MEGA S or MEGA PRO, set your Bed size in your Slicer to these values.
- Use Cura, PrusaSlicer or xLoader to flash the Firmware to your Printer.
Important: Be sure to select "LOAD FW DEFAULTS" and "SAVE EEPROM" via Special Menu after updating! *
*You may not have to reset everything.
However, the prerequisites for this are difficult to tell, which is why I wrote something this topic here in english and here in german.