Skip to content

@Laser4DIY Laser 4 DIY

Change the repository type filter

All

    Repositories list

    14 repositories

    • XY-Table

      Public
      Low Profile XY Table for Laser4DIY
      1•3•3•0•Updated Oct 31, 2023Oct 31, 2023

    • Laser4DIY-Coin

      Public
      Laser4DIY Coin Demo PCB
      0•0•0•0•Updated Jun 21, 2023Jun 21, 2023

    • Laser4DIY_Enclosure

      Public
      OpenSCAD
      •3•8•0•0•Updated Jun 20, 2023Jun 20, 2023

    • Laser4DIY_Electrical

      Public
      Circuit diagrams for the Laser4DIY project
      1•1•0•0•Updated Feb 15, 2023Feb 15, 2023

    • Laser4DIY_AssemblyGuide

      Public
      0•0•0•0•Updated Oct 26, 2022Oct 26, 2022

    • LaserSource

      Public
      1•1•1•0•Updated Oct 17, 2022Oct 17, 2022

    • grbl

      Public archive
      Laser4DIY xy table firmware; GRBL fork
      C
      •
      Other
      •3•0•0•0•Updated Oct 6, 2022Oct 6, 2022

    • Laser4DIY_LaserShutter

      Public
      An open hardware laser shutter, designed to improve the safety of laser cutters and laser experiments
      0•0•2•0•Updated May 5, 2022May 5, 2022

    • GRBL-Advanced

      Public
      Grbl-Advanced is a no-compromise, high performance, low cost alternative for CNC milling. This version of Grbl runs on a STM32F411RE / STM32F446RE Nucleo Board. Now with backlash compensation, multi-axis and Tool Table support!
      C
      •
      GNU General Public License v3.0
      •87•0•0•0•Updated Jan 26, 2022Jan 26, 2022

    • Laser-Driver-v2

      Public
      MCU-based multipurpose Laser Diode driver
      C++
      •7•18•0•0•Updated Jun 5, 2021Jun 5, 2021

    • Laser-Driver

      Public
      Opensource multipurpose laser-diode driver (inital version)
      C++
      •4•4•0•0•Updated Feb 19, 2021Feb 19, 2021

    • grbl-v1.1

      Public archive
      An open source, embedded, high performance g-code-parser and CNC milling controller written in optimized C that will run on a straight Arduino
      C
      •
      Other
      •1.6k•0•0•0•Updated Jan 25, 2021Jan 25, 2021

    • TEC-Controller

      Public
      Laser4DIY TEC Controller
      C++
      •4•9•2•0•Updated Nov 10, 2018Nov 10, 2018

    • Mr-Beam-Shield

      Public archive
      A shield combining three stepper motor drivers and a laser diode driver compatibe to the fabulous grbl cnc firmware.
      Perl
      •
      Other
      •6•0•0•0•Updated May 25, 2018May 25, 2018