Skip to content

Hardware Itead Sonoff Touch

Gerald Ebberink edited this page Jan 26, 2019 · 2 revisions

Itead Sonoff Touch

Sonoff Touch

Property Value
Manufacturer Itead Studio
Product page https://www.itead.cc/sonoff-touch.html
Wiki page https://www.itead.cc/wiki/Sonoff
Build flag ITEAD_SONOFF_TOUCH
Voltage 3v3

Introduction

TODO

Flashing

Sonoff Touch - Inside back view

The Sonoff Touch is a bit tricky to flash since GPIO 0 is not connected to the button as in the TH or POW. So you have to locate the pad for GPIO 0 and short it to ground while powering on the device, once it is on in flash mode you can remove the GND connection.

The picture above shows the location of the GPIO 0 pad. The other required pins are available on the header at the top which has to be soldered in the existing slots.

Once flashed you can use OTA to update the firmware without having to open the device.

Issues

The original Sonoff has some connectivity issues. This is probably due to the antenna placement close to live lines. It works fine if it's near the AP, otherwise, it's often reported to lose connectivity.

The header cannot remain after flashing. At the bottom, it comes too near the powerlines while at the top, it does not fit behind the front.

Home
Change log

Getting started

Supported hardware and options

Configuration

Integrations

Network

Developers

More around ESPurna

Clone this wiki locally